I tried playing it with a drum stick and it did not sound too good

If it were any smaller it would be almost useless. If it were any bigger it would be too cumbersome. Papa bear says this one is just right.

adjust the height on the mic stand and the length away from mic stand, as well as the angle with one thumbscrew

Well built, nothing fancy but it gets the job done.

A little over priced but like they say, if you can build a better mouse trap...

wouldnt realy no

Active Musician

Rock, soul, RnB

The sound on this thing is awesome! It doesn't hiss, pop, or add any noise artifacts when I am recording in my studio. It does what it is supposed to do, sit there and hold my sheet music.

It is a very cool idea, since it saves having to have another piece of equipment taking up floor space in your studio. It just clamps on the cymbal upright on my drum set and I have my sheet music or notes right in front of me.

The product works well even though it is a little small. The build quality is pretty sad and can be irritating when you think that there isn't a better product out there for the money.

The quality of this product is cheap. I had to swap the horizontal bar around to the right hand side and stripped the heads of most of the screws in the process. If they hadn't used the weakest metal possible I would have had more success. Also, when they welded on the alignment tube, it is not quite square, so the stand tends to droop when used on one side of the stand, and tilts upwards on the other side.

It is a clever and space saving idea, but it would have been a much better value if they hadn't used the cheapest materials possible.

Hobbyist

Rock

This is a decent stand, but make sure if you order it you note that it is for mic stands. It does not fit music stands, or at least those with a little thicker stand material.

Musician

Rock, Country, Alternative

Especially since it's not a musical instrument.

Awful design. The stand part is fine, but the clamp is useless. It's plastic, with a screw to grind directly into the stand. Even when screwed tight enough to do damage to the microphone stand, the stand will hang crooked. Furthermore, the design only allows placement to the right of the stand, not to the left.